armor belt造句

• The armor belt varied from 220 to 280 mm in thickness.
• He also found no torpedo damage on the armor belt, echoing previous findings.
• The main armor belt was retained, but was reduced in height to save weight.
• All four ships retained teak backing to their armor belts.
• Her armor belt was wide amidships and extended above and almost below the waterline.
• Their armor belts also sat below the ships'waterlines, which made them of limited benefit.
• The main armor belt was retained, although it was reduced in height to save weight.
• "Dante Alighieri " had a complete waterline armor belt that had a maximum thickness of.
• A section of armor belt was lost and numerous holes were torn in her hull.
• Their armor belts were the same thickness but were more extensive than that of their predecessor.
• The waterline armor belt of the " Borodino " s consisted of Krupp armor and was thick.
• A typical Washington design had in its armor belt, and less on other areas of the ship.
• The ship's waterline armor belt was thick and the main battery was protected by up to of armor.
• One torpedo hit " Andrey Pervozvanny " armor belt, killing one sailor and flooding an isolated watertight compartment.
• The armor belt of was planned.
• The middle deck was the primary armored deck and was connected to the top of the armor belt.
• The second torpedo detonated below the armor belt and turret 3 at frame 101, causing nearly identical damage.
• These included sixteen 65-armor belt was thick and the main battery was protected by up to of armor.
• One splinter struck " Mass閚a " above her armor belt and left a 15-centimetre sized hole in her hull.
• Typically, the main armor belt covers the warship from its main deck down to some distance below the waterline.